Neck Pro Overdoor Cervical Traction Device - NeckPro™門上使用頸部牽引裝置

NeckPro™ cervical traction device is easy-to-use at home, to significantly reduce neck pain. Unlike other cervical traction devices, which may rely on water-bags or heavy weights to create the therapeutic tension, NeckPro™ relies on a simple cord device. With every pull and click of the cord, the tension increases by approximately one pound. A maximum of 20 pounds of tension is possible.

Direction of Use:

Use as directed by your licensed medical practitioner to be sure you have no medical or physical condition which could preclude its use. Use only according to instructions below. DO NOT modify or disassemble. Keep away from children.

The Adjustable Door Bracket fits standard doors measuring 1-3/8”, 1-1/2”, 1-5/8”, 1-3/4”, 35 mm and 44 mm doors.

Step 1: Determine the correct side of the door. To determine which side of the door the bracket should face, locate the hinges on the hinge side of the door. The bracket should be placed on the same side of the door where the hinges are visible with the door closed. If the bracket is placed on the wrong side of the door, the bracket will interfere with the door jamb and prevent the door from closing properly.

Step 2: Determine the width of your door. Set the door width with by inserting the pin into the hole with your door width marked. You may need to slide the top portion of the bracket back and forth until the holes line up as need to fit your door before you put in the locking pin.

Step 3: Once the door width is set, you can place it on top of your door. Close your door to secure the bracket in place.

WARNING: DO NOT use the device WITHOUT the door closed completely!!!

Step 4: Press down on the release tab to lower the head harness to the length needed when you are sitting down.

Step 5: Place chair so that the back is pushed against the door. Sit in the chair with your back firmly against the back of the chair.

Step 6: Apply the head harness to the back of the head and chin. For comfort, place chinstrap so that it embraces the forward structure of the chin in a cupping or concave manner. Pull hook and loop strap forward and attach to the Velcro patches on both sides of the chin strap. Ensure that the harness fits snug at the back of the neck and chin.

Step 7: Once the harness is properly secured to the head, pull the white cord slowly to take the slack out of the harness. When you sense the first tug or lift, begin counting clicks. Each click equals approximately one (1) pound of traction pull. Ease up on the cord after each click to get a full sense of the increased traction/tension before increasing to next level. For safety purposes, this device is limited to approx. 25 lbs. of traction/tension pull. Once you reach the limit, it is designed NOT to increase beyond that.

To release/remove the head halter, grasp the ends of the Velcro straps, pull back and up behind the ear for quick and easy removal.

Recommended regimen: Apply traction to level where relief is achieved; approximately 5 – 10 lbs (clicks). Hold at that level for 5 minutes. Release and then apply again for an additional 5-10 minutes. This can be done as many times as needed during the day to obtain therapeutic pain relief as directed by your licensed medical practitioner.

NeckPro™門上牽引裝置 

NeckPro™頸椎牽引裝置在家中使用方便，可顯著減輕頸部疼痛。與其他可能依靠水袋或重物來產生治療性張力的頸椎牽引裝置不同，NeckPro™依靠的是一個簡單的繩索裝置提供牽引力。每拉動一次繩索和點擊一次，張力就會增加大約一磅。最多可以有20磅的張力。

使用方法：

請按照您的執業醫師的指示使用，以確保您沒有可能妨礙使用的醫療或身體狀況。只能按照以下說明使用。請勿修改或拆卸。請遠離兒童。

可調式門托架適用於1-3/8英寸、1-1/2英寸、1-5/8英寸、1-3/4英寸、35毫米和44毫米的標準門。

第一步：確定門的正確一側。要確定托架應該朝向門的哪一面，在門的鉸鏈一側找到鉸鏈。支架應該放在門的同一側，在門關閉的情況下可以看到鉸鏈。如果托架放在門的錯誤一側，托架就會與門框產生幹擾，妨礙門的正常關閉。

第二步：確定你的門的寬度。將銷子插入標有門寬的孔中，設定門寬。您可能需要來回滑動托架的頂部部分，直到孔符合門的間隙，然後再放入鎖銷。

第3步：一旦門的寬度設定完畢，就可以把它放在門的上面。關上門，將支架固定到位。

警告：在門沒有完全關閉的情況下，請不要使用該裝置！！！

第4步：按下 ‘釋放’（Release）標簽，將頭部安全帶降至您坐下時對應的長度。

第5步：放置椅子，使其背靠著門。坐在椅子上，背部緊貼椅背。

第6步：將頭帶套在下巴後部。為了舒適起見，將下巴套使其以杯狀或凹狀的方式緊貼下巴的前方結構。將鉤環帶向前拉，連接到下巴帶兩側的魔術貼上。確下巴套在頸部和下巴處緊貼。

第7步：一旦安全帶正確地固定在頭部，慢慢拉動白色繩索是其沒有鬆動。當你感覺到第一次拉動或擡起時，開始計算。每一聲相當於大約一（1）磅的牽引力。每次拉動後，放松繩子，以充分感受到增加的牽引力/張力，然後再增加到下一個級別。為了安全起見，本設備的牽引力/張力限製在25磅左右。一旦達到極限，它的牽引力就不會再增加。

要松開/取下頭箍，請抓住尼龍搭扣帶的兩端，向後拉，並在耳後上提，以便快速、輕松地取下。

建議使用的方法。將牽引力施加到達到緩解的水平；大約5-10磅。在該水平上保持5分鐘。松開，然後再次使用，再持續5-10分鐘。這可以在一天中根據需要多次進行，以獲得治療性的疼痛緩解，具體方法由您的執業醫師指導。